| Installation Tools | Spot Face Tool for sensor installation. |
| Spot Face Tool Length | 01 – Ø20mm / Ø0.8in, 02 – Ø32mm / Ø1.3in. |
| Mounting Thread | 01 – ¼-28” UNF Female, 02 – M8 Female, 03 – M6 Female. |
| Spot Face Tool Only | HS-AA001-1/4 – Ø32mm/Ø1.3in for 1/4”-28 UNF Thread, HS-AA001-M6 – Ø32mm/Ø1.3in for M6 Thread, HS-AA017-1/4 – Ø20mm/Ø0.8in for 1/4”-28 UNF Thread, HS-AA017-M6 – Ø20mm/Ø0.8in for M6 Thread, HS-AA017-M8 – Ø20mm/Ø0.8in for M8 Thread. |
| Key Features | Portable and compact. Creates flat surface to ensure effective mount for accelerometers. Available with various mounting thread options. Requires pistol drill. |
| Certifications | EMC: 5700 and TB EAC EMC Declaration of Conformity (RU), Area: Eurasian Community, Number: ЕАЭС N RU Д-IT.PA08.B.82359/24, Issued by: CONTROL, Issue Date: 2024-09-26. |
| Declarations of Conformity | EU Declaration Termination Boards TB, TBE, TUE (EN | IT); Declaration of Conformity G3 compliance (EN). |
| Supply Type | 24 Vdc nom (20 to 30 Vdc) reverse polarity protected, double terminal blocks for redundant power supply, with OR diodes to mix supply voltages. |
| Connection | By polarized plug-in disconnect screw terminal blocks to accommodate terminations up to 2.5 mm². |
| LED Indication | 2 green LEDs, one for each power supply (supply 1 and supply 2). |
| Protection Fuse | 2 A time lag, spare fuse provided on Termination Board. |
| Preventive Fault Detection | Supply 1 or Supply 2 is < 18 Vdc (Under Voltage) or > 30 Vdc (Over Voltage). |
| Critical Fault Detection | Both supplies in UV or OV condition or cumulative fault indication for short/open field circuit on any DO channel. |
| LED Fault Signaling | 2 red LEDs (UV/OV for supply 1), 2 red LEDs (UV/OV for supply 2), 1 cumulative red LED. |
| Relay Fault Signaling | Voltage free NE SPDT relay contact (de-energized in fault). |
| Relay Contact Rating | 2 A 36 Vac 72 VA, 2 A 48 Vdc 80 W (resistive load). |
| FBM200 I/O Card Interface | Two 25-pole SUB-D male connectors (requires female mating connectors). |
| HART Multiplexing Connection | 34-pole male connector (requires female mating connector). |
| Operating Conditions | Temperature: -40 to +70 °C, RH max 90 %, non-condensing, up to 35 °C. |
| Storage Conditions | -45 to +80 °C. |
| Mounting | Hardware included for wall and DIN rail mounting. |
| Weight | About 220 g (excluding modules and mounting options). |
| Location | Safe Area / Ordinary locations. |
| Dimensions | Width 147 mm, Depth 176 mm, Height 125 mm. |
