5700

The HART® Multiplexer Modem 5700 interfaces up to 256 smart devices (transmitters, I/P, proportional valves, etc…) in a HART® Network. Each device can be fully identified, configured and monitored by a remote PC running an FDT-based software package (PACTware™, etc…) through a dedicated Device Type Manager (DTM). The module is intended to be mounted on the following Termination Boards:

• TBE-D5001-HRT-003: to be used with G.M. International AI/AO Termination Boards
• TBE-D5001-HRT-004: to be used with DIN-Rail mounted barriers/isolators or direct field connections, for 4-20mA loop signal
• TBE-D5001-HRT-005: to be used with DIN-Rail mounted barriers/isolators or direct field connections, for 1-5V loop signal

• TBE-D5001-HRT-006: to be used with DIN-Rail mounted barriers/isolators or direct field connections, for 4-20mA loop signal and for AI cards with 100 Ω to 150 Ω input impedance
• TBE-D5001-HRT-007: to be used with DIN-Rail mounted barriers/isolators or direct field connections, for 4-20mA loop signal and for AI cards with 0 Ω to 50 Ω input impedance

Termination board types can be combined to manage different interfaces at the same time, simply respecting maximum number of connected channels. The HART® Multiplexer Modem 5700 is SIL 3.
In order to communicate with the hardware, an RS232/RS485 converter should be connected to the serial port of the Host. The suggested converter is the D1061S.

The minimum required software tools, to be able to operate the HART® network, are the following:

• •

PACTware™ software

• •

HART® Mux 5700 DTM

• •

SWC5090 Configuration software

FEATURES

• SIL 3 / SC 3
• Input from Zone 2, installation in Zone 2.
• Up to 256 channels (extendable to 16128 with 63 multi-drop units).
• HART® RS-485 interface to access field smart devices.
• Three port isolation, Field Interface/Serial Interface/Supply.
• Simplified installation on custom Termination Boards.