| Supply Voltage | 24 Vdc nom (20 to 30 Vdc) reverse polarity protected, ripple within voltage limits ≤ 5 Vpp. |
| Current Consumption | 80 mA with four 350 Ω load cells connected, typical. |
| Power Dissipation | 1.7 W with 24 V supply and four 350 Ω load cells connected typical. |
| Max. Power Consumption | At 30 V supply voltage and short circuit input, 2.8 W. |
| Input Type | Up to four 350 Ω, six 450 Ω, or twelve 1000 Ω load cells in parallel. |
| Bridge Supply Voltage | 4.5 V nominal. |
| Bridge Output Signal | ≤ 4 mV/V. |
| Input Range | ± 18 mV nominal span, ± 22 mV overrange. |
| Line Resistance Compensation | ≤ 10 Ω. |
| Burnout Type | LED indication for field wire breakage. |
| Output Type | ± 20 mV nominal span, ± 24 mV overrange (5 V ref); ± 40 mV nominal span, ± 48 mV overrange (10 V ref). |
| Output Impedance | 350 Ω typical. |
| Host Reference Voltage | ≤ 10 V typical, ≤ 11 V maximum. |
| Internal Reference Voltage | 10 V typical, DIP switch settable. |
| Internal Impedance | 350 Ω typical, DIP switch settable. |
| Transfer Characteristic | Linear based on mV input. |
| Response Time | ≤ 100 ms (10 to 90 % step change). |
| Performance Type | Ref. conditions 24 V supply, 23 ± 1 °C ambient temperature. |
| Calibration Accuracy | ≤ ± 0.003 % of full scale of input range. |
| Linearity Accuracy | ≤ ± 0.002 % of full scale of input range. |
| Supply Voltage Influence | ≤ ± 0.002 % of full scale for a min to max supply change. |
| Temperature Influence | ≤ ± 0.002 % of full scale of input range for a 1 °C change. |
| Isolation Test Voltage | I.S. In/Out 1.5 kV; I.S. In/Supply 1.5 kV; Out/Supply 500 V. |
| Operating Conditions | Temperature limits –20 to +60 °C, RH max 90 % non-condensing up to 35 °C. |
| Storage Conditions | Temperature limits –45 to +80 °C. |
| Safety Parameters | Uo = 17.3 V, Io = 199.6 mA, Po = 864 mW at terminals 9–14; Ui = 30 V, Ci = 0 nF, Li = 0 nH; Um = 250 Vrms, –20 °C ≤ Ta ≤ 60 °C. |
| Mounting Type | EN/IEC60715 TH 35 DIN-Rail. |
| Weight | About 165 g. |
| Connection | By polarized plug-in disconnect screw terminal blocks to accommodate terminations up to 2.5 mm². |
| Location | Safe Area/Non Hazardous or Zone 2, Class I, Div 2, Group IIC T4 installations. |
| Protection Class | IP 20. |
| Dimensions | Width 22.5 mm, Depth 99 mm, Height 114.5 mm. |
